Differences between revisions 26 and 27
Revision 26 as of 2005-12-11 02:53:30
Size: 10808
Editor: GeraldCombs
Comment: The "manuf.txt" on the main site was outdated. Point to SVN instead.
Revision 27 as of 2006-02-19 12:03:16
Size: 10809
Editor: UlfLamping
Comment: typo
Deletions are marked like this. Additions are marked like this.
Line 35: Line 35:
 A destination MAC address where the low-order bit of the first byte is set indicats a ["Multicast"], meaning the packet is sent from one host to all hosts on the network interested in packets sent to that MAC address. A number of multicast addresses have been assigned; see [http://www.iana.org/assignments/ethernet-numbers Ethernet numbers] at the ["IANA"], [http://www.cavebear.com/CaveBear/Ethernet/multicast.html Michael A. Patton's list of multicast addresses], and [http://anonsvn.ethereal.com/ethereal/trunk/manuf Ethereal's list of Ethernet vendor codes and well-known MAC addresses], from the Ethereal source distribution, for assigned multicast addresses.  A destination MAC address where the low-order bit of the first byte is set indicates a ["Multicast"], meaning the packet is sent from one host to all hosts on the network interested in packets sent to that MAC address. A number of multicast addresses have been assigned; see [http://www.iana.org/assignments/ethernet-numbers Ethernet numbers] at the ["IANA"], [http://www.cavebear.com/CaveBear/Ethernet/multicast.html Michael A. Patton's list of multicast addresses], and [http://anonsvn.ethereal.com/ethereal/trunk/manuf Ethereal's list of Ethernet vendor codes and well-known MAC addresses], from the Ethereal source distribution, for assigned multicast addresses.

Ethernet (IEEE 802.3)

TableOfContents(2)

Overview

Ethernet is the most common local area networking technology, and, with gigabit and 10 gigabit Ethernet, is also being used for metropolitan-area and wide-area networking.

It is specified by [http://standards.ieee.org/getieee802/802.3.html various IEEE 802.3 specifications].

Ethernet sends network packets from the sending host to one (["Unicast"]) or more (["Multicast"]/["Broadcast"]) receiving hosts.

You can find hardware related Ethernet information at the EthernetHardware page.

Information how to capture on an Ethernet network can be found at the ["CaptureSetup/Ethernet"] page.

Packet format

A physical Ethernet packet will look like this:

Preamble

Destination MAC address

Source MAC address

Type/Length

User Data

Frame Check Sequence (FCS)

8

6

6

2

46 - 1500

4

As the Ethernet hardware filters the preamble, only the green fields are given to Ethereal or any other application. Most Ethernet interfaces also either don't supply the FCS to Ethereal or other applications, or aren't configured by their driver to do so.

MAC address fields

Type / Length field

  • The original DEC/Intel/Xerox Ethernet specification included a 16-bit type field to indicate what upper layer protocol should be used. Ethernet frames with less than 64 bytes of Ethernet header, user data, and FCS are padded to 64 bytes (which means 60 bytes of Ethernet header and user data), which means that if there's less than 64-(14+4) = 46 bytes of user data in the frame, extra user data is added to the frame. If the upper layer protocol implementation has to know exactly how much user data is in the packet, and expects the length of the Ethernet packet to indicate the amount of user data, it will not behave correctly with padded packets.

    When constructing standards for LANs, the IEEE added a new header, the [http://standards.ieee.org/getieee802/802.2.html 802.2] LLC header, to packets in those LANs. It contained a destination "service access point", source "service access point", and packet type field, similar to the packet type field used in HDLC and HDLC-derived protocols such as X.25's LAPB; the destination service access point indicated the service to which the packet should be delivered, where a "service" is implemented as a protocol. (XXX - is the notion of service and protocol formalized in the OSI reference model? If so, we should perhaps have a page for the OSI model and describe that notion, and link to it.) I.e., it indicates the upper layer protocol that should be used. This meant that the type field in Ethernet could be used for other purposes, if an 802.2 header appeared at the beginning of the user data, so the IEEE standard for Ethernet, IEEE 802.3, included after the source MAC address a 16-bit field indicating the length of the user data in the packet, for the benefit of protocols that couldn't infer the length of the user data from the length of the packet as received.

    However, that standard also had to support the traditional use of that field as a type field. Ethernet packets could have no more than 1500 bytes of user data, so the field is interpreted as a length field if it has a value <= 1500 and a type field if it has a value > 1500. (XXX - the maximum length value is slightly smaller than the minimum type value.) Therefore, if the type/length field has a value 1500 or lower, it's a length field, and is followed by an 802.2 header, otherwise it's a type field and is followed by the data for the upper layer protocol.

    For a more detailed discussion of this, which mentions a third possibility used by NetWare, and mentions the SNAP header that can follow the 802.2 header, see [http://www.ee.siue.edu/~bnoble/comp/networks/frametypes.html Ethernet Frame Types: Provan's Definitive Answer], by Don Provan. Some examples of values in the type/length field:

    • 0 - 45 invalid
    • 46 - 1500 length field (802.3 + 802.2)
    • 0x0800 IP(v4), Internet Protocol version 4
    • 0x0806 ARP, Address Resolution Protocol
    • 0x8137 IPX, Internet Packet eXchange (Novell)
    • 0x86dd IPv6, Internet Protocol version 6

    See [http://www.iana.org/assignments/ethernet-numbers Ethernet numbers] at the ["IANA"], [http://www.cavebear.com/CaveBear/Ethernet/type.html Michael A. Patton's list of Ethernet type codes], and [http://standards.ieee.org/regauth/ethertype/eth.txt the IEEE's list of public Ethernet type assignments] for lists of some assigned Ethernet type codes. You can also search for a particular Ethernet type from [http://standards.ieee.org/regauth/ethertype/index.shtml the IEEE EtherType Registration Authority page]; enter the Ethernet type in hex, without a leading 0x. (Not all assigned Ethernet type codes are reported publicly.)

Frame Check Sequence (FCS) field

  • Ethernet uses a CyclicRedundancyCheck (CRC) algorithm to detect transmission errors. The FrameCheckSequence field is filled (using a CRC) by the sending host. If the receiving host detects a wrong CRC, it will throw away that packet.

History

See [http://en.wikipedia.org/wiki/Ethernet#History Wikipedia] for a brief history of Ethernet

Protocol dependencies

Ethernet is the lowest software layer, so it only depends on hardware.

Example traffic

Small portion of the capture from opening ethereal.com in a web browser.

  • No.     Time        Source                Destination           Protocol Info
          1 0.000000    192.168.2.3           mail.packet0.com      TCP      1061 > http [SYN] Seq=0 Ack=0 Win=16384 Len=0 MSS=1460
          2 0.063590    mail.packet0.com      192.168.2.3           TCP      http > 1061 [SYN, ACK] Seq=0 Ack=1 Win=5840 Len=0 MSS=1380
          3 0.063665    192.168.2.3           mail.packet0.com      TCP      1061 > http [ACK] Seq=1 Ack=1 Win=16560 Len=0
          4 0.064056    192.168.2.3           mail.packet0.com      HTTP     GET / HTTP/1.1
          5 0.163470    mail.packet0.com      192.168.2.3           TCP      http > 1061 [ACK] Seq=1 Ack=399 Win=6432 Len=0
          6 0.193849    mail.packet0.com      192.168.2.3           HTTP     HTTP/1.1 200 OK (text/html)
          7 0.201317    mail.packet0.com      192.168.2.3           HTTP     Continuation
          8 0.201408    192.168.2.3           mail.packet0.com      TCP      1061 > http [ACK] Seq=399 Ack=2761 Win=16560 Len=0
          9 0.208895    192.168.2.3           mail.packet0.com      TCP      1062 > http [SYN] Seq=0 Ack=0 Win=16384 Len=0 MSS=1460
         10 0.280617    mail.packet0.com      192.168.2.3           HTTP     Continuation
         11 0.287876    mail.packet0.com      192.168.2.3           HTTP     Continuation

Example capture file

Full capture from above example. Opening www.ethereal.com from the Firefox browser.

  • attachment:SampleCaptures/ethereal.com.pcap.gz

Ethereal

The Ethernet dissector is fully functional.

Preference Settings

(XXX add links to preference settings affecting how Ethernet is dissected).

Display Filter

A complete list of Ethernet display filter fields can be found in the [http://www.ethereal.com/docs/dfref/e/eth.html display filter reference]

Some useful filters:

  • Filter

    Traffic Description

    eth 

    all Ethernet based

    eth.addr==08.00.08.15.ca.fe 

    to and from Ethernet MAC address 08:00:08:15:ca:fe

    !(eth.addr==08.00.08.15.ca.fe) 

    all except to and from Ethernet MAC address 08:00:08:15:ca:fe

    eth.dst==ff:ff:ff:ff:ff:ff 

    Ethernet ["Broadcast"] only

    eth.dst!=ff:ff:ff:ff:ff:ff 

    all except Ethernet ["Broadcast"]

    (eth.dst[0] & 1) 

    Ethernet ["Multicast"] only (least significant bit of first address byte set)

    !(eth.dst[0] & 1) 

    all except Ethernet ["Multicast"] (least significant bit of first address byte not set)

Note: the Ethernet Broadcast address (ff:ff:ff:ff:ff:ff) is per definition a Multicast one (least significant bit of first address byte set). If you want to see only Multicasts, you have to filter out the Broadcasts as well  (eth.dst[0] & 1) && eth.dst!=ff:ff:ff:ff:ff:ff .

Capture Filter

Capture only the Ethernet-based traffic to and from Ethernet MAC address 08:00:08:15:ca:fe:

  •  ether host 08:00:08:15:ca:fe 

Ethernet ["Multicast"] traffic only:

  •  ether multicast 

Ethernet ["Broadcast"] traffic only:

  •  ether broadcast 

Information how to capture on an Ethernet network can be found at the ["CaptureSetup/Ethernet"] page.

A lot of tutorial information about Ethernet can be found at [http://www.ethermanage.com/ethernet/ethernet.html Charles Spurgeon's Ethernet Web Site].

Discussion

Ethernet (last edited 2011-04-25 22:24:29 by BillMeier)